Shell Specifications
Length: 40ft to 80ft (12.19 to 24.38 metre)
Beam: 11ft 6” (3.50 metres) (other beams considered)
Draft: 2ft 6” (0.762 metres)
Air draft: 8ft 10” (2.69 metres)
Air draft (wheelhouse collapsed): 5ft 11” (1.8metres)
Base plate: 15mm
Hull sides: 6mm
Cabin sides: 5mm
Cabin Roofs: 5mm
Bulkheads: 5mm
Angled Strengtheners: 70 x 70 x 10mm
100 x 10mm rubbing strike (Attached around boat)
50 x 15mm convex rubbing strike (Attached around boat)
10 x Tieing bollards
Rudder
2” Weld in PSS Drip-less Stern gland
Twin diesel tanks (pressure tested) 1200/500 litre tanks engine/generator/heating connections
Keel cooling skin tank (raw water cooled also available)
Gas/Chain locker
6 x Magnesium Anodes
Windows & Door apertures cut to suit customer requirements
Self draining decks
Hand rails around boat
Engine bed to suit customer’s engine
Primed in epoxy self etching primer
Comastic below water line and to sub gun whale level (other options available)
ALL ABOVE SPEC IS OUR STANDARD BUILD
ALL OUR SHELLS ARE BUILT TO CAT “C”
SHELL PRICES FROM £45,000 (All above spec included)
Design Categories
Category |
Significant Wave Height |
Wind Forces |
A- Ocean |
Exceeding 4m |
Exceeding 8 |
B- Offshore |
Up to & including 4m |
Up to & including 8 |
C- Inshore |
Up to & including 2m |
Up to & including 6 |
D- Sheltered |
Up to & including 0.3m |
Up to & including 4 |
(Significant wave height means the average height of the highest 1/3rd of the waves over a given period; waves of double this height may occasionally be experienced)
- OCEAN: Designed for extended voyages where conditions mat exceed wind force 8 (Beaufort scale) and significant wave heights of 4m and above but excluding abnormal conditions. Vessels are largely self-sufficient.
- OFFSHORE: Designed for offshore voyages where conditions up to and including, wind force 8 and significant wave heights up to and including 4m may be experienced.
- INSHORE: Designed for voyages in coastal waters, large bays, estuaries, lakes and rivers where conditions up to and including wind force 6 and significant wave heights up to and including 2m may be experienced.
- SHELTERED WATERS: Designed for voyages on sheltered coastal waters, small bays, small lakes, rivers and canals when conditions up to and including wind force 4 and significant wave heights up to and including 0.3m may be experienced, with occasional waves of 0.5m maximum height, for example from passing vessels.
Engine Options
All the engines above are just some of the propulsion engines that can be fitted
All engines are installed fully operational with:
Ultraflex Single top mount control unit
Engine Panel
Fuel lines with water/sediment trap (200 litres fuel)
12 volt 160Ah Starter battery
Hospital silencer (lagged)
PRM 500d Hydraulic gearbox
Vetus Bullflex coupling (Aqua drive system for Aft Cabin option)
2” Stainless steel Shaft
PSS Drip-less shaft system
3 Blade 24” Propeller (Crowther Marine)
ENGINE PRICES £14,000 to £17,000 (fully operational) |
